Glass LCD 4.3″ for JK INVERTER PB BMS

Touchscreen LCD for JK INVERTER PB BMS

A screen intended exclusively for the BMS JK Inverter with a UART socket (from version V19) allows for monitoring the current status of the package parameters.

The screen does not work with other BMS JK systems.

Unlike the traditional JK 4.3″ screen, this screen connects to a separate UART socket and doesn’t have its own power switch. To turn off the BMS, use the switch included with the BMS kit.

The screen is mounted using adhesive tape. Because the inner part is smaller than in the traditional JK 4.3″ screens, it can be mounted in the housing openings prepared for the previous version.

In the following tabs you can observe the general parameters of the package:

• Screen 1 – charge status, voltage, charging or discharging current, balancer status
• Screen 2 – voltages of individual cells
• Screen 3 – setting communication protocols – with the ability to change.

In the case of using the screen for several energy storage systems connected in parallel and communicating via an RS485 link, it’s possible to display parameters (voltage, current, state of charge, cell voltage) for each system on a single monitor. The screen must be connected to the BMS Master, and all energy storage systems must have the BMS JK Inverter in version V19.

The screen is supplied with a connecting cable. With this screen, it is possible to set the BMS so that the screen remains on all the time – e.g. when operating large energy storage facilities.